Basic Operation
3-18
Interrupt Copy
This function allows you to pause the current jobs in progress when you need to make copies immediately.
When the interruption copy ends, the machine resumes the paused print jobs.
NOTE: If the machine is left unused for 60 seconds in interrupt copy mode, interrupt copying is automatically
canceled and printing resumes. You can change the delay until interrupt copying is canceled. Change the delay
as required. For more information, refer to Interrupt Clear Timer on page 9-81.
1 Press the Interrupt key.
The current print job is temporarily interrupted.
2 Place the originals onto the machine for interrupt
copy, and configure the copy settings.
3 Press the Start key to start interrupt copying.
4 When interrupt copying ends, press the Interrupt
key.
The machine resumes the paused print jobs.
To Next Page
Loading...
Need help?
General
