Default Setting (System Menu)
9-81
9
Interrupt Clear Timer
Set the period after which the machine reverts to Normal mode when it has been set to Interrupt Copy mode
and then left unused. Any period between 5 and 495 seconds (in five-second increments) can be set.
The procedure for setting the interrupt clear timer is explained below.
1 Press the System Menu key.
2 Press [ ], [Date/Timer], [ ] and then [Change] of Interrupt Clear Timer.
3 Press [+] or [-] to enter the time for the interrupt clear timer.
4 Press [OK].
Error Job Skip
Set whether a job for which a "Add paper in cassette #" or "Add paper in Multi Purpose tray" error occurred when
the job was started is automatically skipped after a set period of time elapses. The period of time can be set
within the range 5 to 90 seconds (increments of 5 seconds).
NOTE: When a job is skipped, it is moved to the end of the job queue.
The procedure for setting the Error Job Skip is explained below.
1 Press the System Menu key.
2 Press [ ], [Date/Timer], [ ] and then [Change] of Error Job Skip.
3 Press [Off] or [On].
4 If you selected [On], set the time until the job is skipped with [+] or [-].
5 Press [OK].
To Next Page
Loading...
Need help?
General
