Default Setting (System Menu)
9-82
Sleep Act. (Job Separator)
When the optional Inner Job Separator (JS-732) is attached and printed output remains on the job separator
tray, the busy light stays lit until the output is removed. This setting determines whether the machine enters
Sleep Mode after a certain period of time when in this state.
NOTE: This appears when the optional Inner Job Separator (JS-732) is attached and the Auto Sleep setting
(page 9-79) is set to [On].
The table below shows the available settings.
The procedure is as follows.
1 Press the System Menu key.
2 Press [ ], [Date/Timer], [ ] and then [Change] of Sleep Act. (Job Separator).
3 Press [Sleep Priority] or [Indicator Priority].
4 Press [OK].
Item Description
Sleep Priority Sleep mode is entered after a set period of time and the busy light turns
off.
Indicator Priority Sleep mode is not entered after the set period of time and the busy light
stays on until the output is removed.
To Next Page
Loading...
Need help?
General
