Preparation before Use
2-10
Sleep and Auto Sleep
Sleep
To enter Sleep, press the Power key. Touch panel and
all indicators on the operation panel will go out to save
a maximum amount of power except the Main Power
indicator. This status is referred to as Sleep.
If print data is received during Sleep, the print job is
performed while the touch panel remains unlit.
When using the optional fax, received fax data is printed
out while the operation panel also remains unlit.
To resume, press the Power key. The 30/30 ppm or
35/35 ppm model will be ready within 20 seconds, or the
45/45 ppm or 55/50 ppm model will be ready within 30
seconds.
Note that ambient environmental conditions, such as
ventilation, may cause the machine to respond more
slowly.
Auto Sleep
Auto Sleep automatically switches the machine into Sleep if left idle for a preset time in the Low Power Mode.
The default preset time is 30 minutes (for the 30/30 ppm model), 45 minutes (for the 35/35 ppm model), or 60
minutes (for the 45/45 ppm or 55/50 ppm model).
Adjusting the Operation Panel Angle
Adjust the angle of the operation panel in two as shown
by releasing the operation panel lock lever.
To Next Page
Loading...
