Utax CDC 1930

Default Setting (System Menu)
9-24
Margin Default
Set the default margin. The table below shows the measurement ranges that can be set.
Use the procedure below to set the default margin width.
1 Press the System Menu key.
2 Press [Common Settings], [ ], [Next] of Function Defaults, [ ] and then [Change] of Margin Default.
3 Use the [+] or [-] to enter the margin widths for Left/Right and Top/Bottom.
You can use the numeric keys to enter the number directly.
4 Press [OK].
Auto Image Rotation
Select the default Auto Image Rotation setting. The table below shows the available settings.
NOTE: Refer to page 4-44 for Auto Image Rotation.
Use the procedure below to set the default Auto Image Rotation settings.
1 Press the System Menu key.
2 Press [Common Settings], [ ], [Next] of Function Defaults, [ ] and then [Change] of Auto Image Rotation.
3 Select the default for [Off] or [On].
4 Press [OK].
EcoPrint
Select the EcoPrint default. The table below shows the available settings.
NOTE: Refer to page 4-14 for EcoPrint.
Input units Range
Inch -0.75 to 0.75" (in 0.01" increments)
Metric -18 mm to 18 mm (in 1 mm increments)
Item Description
Off No Auto Image Rotation performed.
On Auto Image Rotation performed.
Item Description
Off No EcoPrint performed.
On EcoPrint performed.