Default Setting (System Menu)
9-105
9
LDAP Security
Select the communication protocol according to the type of security employed by the LDAP server. The default
setting is Off.
NOTE: LDAP must be set to [On] in Protocol Detail on page 9-100.
The table below shows the available settings.
* You can change the port number using Embedded Web Server RX.
Use the procedure below.
1 Press the System Menu key.
2 Press [System], [Next] of Network, [ ], [Next] of Secure Protocol, and then [Change] of LDAP Security.
3 Press [Off], [SSL/TLS] or [STARTTLS].
4 Press [OK].
SMTP Security
Select the communication protocol according to the type of security employed by the SMTP server. The default
setting is Off.
NOTE: SMTP must be set to On in Protocol Detail on page 9-100.
The table below shows the available settings.
* You can change the port number using Embedded Web Server RX.
Item Description
Off Do not use security employed by the LDAP server.
SSL/TLS Encryption is applied any data communication. To enable LDAP security, the
LDAP port may have to be changed according to the server settings.
Typically, 636* for SSL/TLS is well-known LDAP port.
STARTTLS Encryption is applied any data communication. Typically, 389* for
STARTTLS is well-known LDAP port.
Item Description
Off Do not use security employed by the SMTP server.
SSL/TLS Encryption is applied any data communication. To enable SMTP security,
the SMTP port may have to be changed according to the server settings.
Typically, 465* for SSL/TLS is well-known SMTP port.
STARTTLS Encryption is applied any data communication. Typically, 25* or 587* for
STARTTLS is well-known SMTP port.
To Next Page
Loading...
