Management
10-6
NOTE: By default, one of each default user with machine administrator rights and administrator privileges is
already stored.
Each user's properties are:
Machine Administrator
User Name: DeviceAdmin
Login User Name: 30/30 ppm model : 3000, 35/35 ppm model : 3500, 45/45 ppm model : 4500,
55/50 ppm model : 5500
Login Password: 30/30 ppm model : 3000, 35/35 ppm model : 3500, 45/45 ppm model : 4500,
55/50 ppm model : 5500
Access Level: Machine Administrator
Administrator
User Name: Admin
Login User Name: Admin
Login Password: Admin
Access Level: Administrator
* Upper case and lower case letters are distinguished (case sensitive).
It is recommended to periodically change the user name, login user name and login password regularly for your
security.
Use the procedure below to register a new user.
1 Login as a user with administrator rights.
2 Press the System Menu key.
3 Press [User Login/Job Accounting].
4 If the user authentication screen appears, enter
your login user name and password and then press
[Login]. For this, you need to login with
administrator privileges. Refer to Adding a User
(Local User List) on page 10-5 for the default login
user name and password.
5 Press [Next] of User Login Setting, [Add/Edit] of
Local User List, and then [Add].
6 Press [Change] of User Name.
7 Enter the user name and press [OK].
NOTE: Refer to the Character Entry Method on
Appendix-9 for details on entering characters.
8 Enter the login user name and E-mail address
following 6 and 7 above.
9 Press [Change] of Login Password and then
[Password].
To Next Page
Loading...
Need help?
General
