Intended Use D291308.2f.fm iii
Intended Use
The intended use of the PT-55 SMD Peel Force Tester is to measure the peel force of sealed
SMD tape. Use of this equipment in any other way is not recommended.
Operating Environment
The PT-55 is designed to be operated in a temperature controlled, light, industrial setting. The
machine should be installed on a flat, dry, stable surface in a well lit area (ambient lighting of 200
to 300 Lux (Lumens/m2).
The recommended climate is between 5 - 90% non-condensing humidity with a room tempera-
ture between 0 - 50 degrees Celsius.
Note: Although all of the components used on the machine will withstand the temperature
range of 0 to 60 degrees Celsius, such temperature may decrease the life of some of the
components.
The intended electrical environment is Pollution Degree 2 and Over Voltage Category II.
Misuse
The user is protected from moving parts and exposure to objects being ejected under pressure
by metal enclosures. The PT-55 should never be operated with these enclosures removed.
To Next Page
Loading...
