General Precautions D291308.2f.fm iv
General Precautions
Only qualified personnel with the proper technical training, experience working on this type of
equipment, and awareness of the possible hazards should perform maintenance on the PT-55.
The PT-55 should be installed on a level and stable surface before any operation or maintenance
is performed.
This manual should be read and thoroughly understood before operating the machine.The guide-
lines provided in the following pages are intended to educate the user about how to operate the
PT-55 safely. They contain important information on avoiding potential hazards to the operator
and to the equipment.
Safety Precautions
Observe the following safety precautions when working with the PT-55.
Maintenance
Please refer to Chapter 3 of this manual before performing maintenance on the
machine.
To p C o v e r
Dangerous voltage is present. When performing maintenance, always discon-
nect the power source from the machine before removing access panels.
Contact Information
V-TEK, Inc.
751 Summit Ave
Mankato, MN 56001
TEL: (507) 387-2039
website: http://www.vtekusa.com
For customer service, please refer to the Customer Service Contact Sheet at the back of this
manual.
To Next Page
Loading...
