V-TEK PT-55 - Calibration Accuracy Verification

D291308.7M.fm Creating an *.maf Export File
Chapter 3: Operation 63
Creating an *.maf Export File
After the desired data has been set in the user fields and a test has been performed, the PT-55
Software can save test data to a Moving Average File (.maf) format. This file is an Excel com-
patible data file which may be used to create a spreadsheet which can then be customized as
desired.
The following information is stored in each record:
• Customer/Machine data
• Carrier Tape data
• Seal Tape data
• Peel Test statistics
• Peel Test results (Reading, Travel, Measured Force and Moving Average)
1. Click File > Export > MAF.
2. Enter the file name and location, then click Save.
Note: The default location is C:\V-TEK\PT-55\Setup Files.
Figure 3.44