Vacon optea - Page 50

5
vacon • 50 Installation
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
Figure 22. Change the option board settings
Step 4. Change the protocol settings.
To change the currently active protocol, select the setting from the tree structure. A dialog box
opens. Select the desired protocol from the dropdown list (Figure 23). After clicking "ok" the setting
will be activated.
The rest of the settings can be changed similarly, but values are edited in the tree (Figure 24). See
Chapter 6 "Commissioning" for more information about the settings.
Figure 23. Change the currently active protocol value