system standby
Gets, sets, or toggles the camera controller's current standby status.
Cameras currently mapped to the camera select buttons also go to standby when you set system
standby on.
Synopsis system standby {get | on | off | toggle }
Options
get
Returns the camera controller's current
standby status.
on
Sets the camera controller to standby mode.
off
Brings the camera controller out of standby
mode.
toggle Changes the camera controller's standby
status.
Examples
system standby get
Returns the factory reset status in this form:
standby: off
(the camera controller is not in standby mode.)
system standby on
Immediately sets the camera controller to standby mode.
system reboot
Reboots the camera controller either immediately or after the specified delay. This also reboots the
cameras currently mapped to the camera select buttons.
Synopsis system reboot [<seconds>]
Options <seconds> The number of seconds to delay the
reboot
Examples
system reboot
Reboots the system immediately.
system reboot 30
Reboots the system in 30 seconds.
48
Integrator's Complete Guide to PCC Premier Precision Camera Controller
To Next Page
Loading...