5. Secure the transmitter to the flange by tightening the screw on the flange that holds the
probe in place.
6. Open the transmitter cover, and route the cables through the cable glands. Connect the
wires to the screw terminals according to the wiring instructions.
7. Tighten the cable gland(s) and close the transmitter cover.
More Information
‣
Component Board (page 13)
‣
Wiring Devices With Analog Output (page 24)
‣
Wiring Devices With Modbus Output (page 27)
3.3 HMW110/112 Installation
• Medium size crosshead screwdriver (Pozidriv) for cover screws.
• Small slotted screwdriver for screw terminals.
• Two installation screws: Ø ≤ 3.5 mm, head Ø ≤ 8 mm.
• Depending on the wall material and screw type, you may need a drill and a
suitable drill bit to make installation holes for screws.
• Tools for cutting and stripping wires.
• 19 mm open-end wrench for tightening the cable gland.
HMDW110 User Guide M211726EN-D
18
To Next Page
Loading...
