5.1 Connecting to Insight Software
• Computer with Vaisala Insight software installed
• USB connection cable (order code 219690)
Before connecting the transmitter to a PC:
• If the terminal block for terminals 5 ... 8 is wired, pull it out. This disconnects
the transmitter from supply voltage and prevents possible equipment damage
that may be caused by ground loops. The locations of the terminal blocks and
the service port are shown in Component Board (page 13).
• If the other terminal block is wired (terminals 1 ... 4), pull it out also. This
prevents the communication between the transmitter and the RDP100 remote
display panel or Modbus (RS-485) host from interfering with your connection.
1. Open the Insight software.
2. Connect the USB cable to a free USB port on the PC.
3. Connect the USB cable to the service port of the transmitter.
4. Wait for Insight software to detect the transmitter.
If the transmitter is not detected, disconnect and reconnect the Vaisala USB cable to the
service port connector of the transmitter.
HMDW110 User Guide M211726EN-D
30
To Next Page
Loading...
