Vaisala PWD22 - Page 112

USER'S GUIDE ____________________________________________________________________
110 _________________________________________________________________ M210543EN-F
X6
RAINCAP
®
connector No. 1. Connect single plate rain
detector to this connector. The cable marked with a black
stripe (forward tilted plate) is connected to X6 in double rain
plate assemblies at PWD22/52.
X7
RAINCAP
®
connector No. 2 is used in PWD22/52 only
(backward tilted plate).
X9
Reset
X10-1 2)
+5 VA
X10-2 2)
AUX: CPU ADC input (internally connected to X3-2)
X10-3 2)
AGND
X11
The jumper between terminals 1 and 2 (default): output pin
X4-5 acts as External relay control 3.
The jumper between terminals 2 and 3: output pin X4-5 acts
as external voltage output.
X12 2)
FLASH programming connector
X13
2)
The jumper between terminals 1 and 2 (default): the analog
current output range is 4 ... 20 mA (pins X3-9 and X3-12).
The jumper between terminals 2 and 3: the analog current
output range is 0 ... 1 mA (pins X3-9 and X3-12).
X14
Module connector
X15
Module connector
X16
Transmitter connector (pin 14 is not used).
X18-1
Background Luminance Sensor PWL111 heater (-, WHT)
X18-2
Background Luminance Sensor PWL111 heater (+, BLU)
1) These signals are guided through the PWC15PB protection board. See the more detailed
connection table in Basic Wiring on page 37.
2) located under the PWC15PB. See also Figure 25 on page 111.