USER'S GUIDE ____________________________________________________________________
70 __________________________________________________________________ M210543EN-F
1206-027
Figure 17 Analog Current Output Connection
If the PWD cable is so long that the 12 V power output is inadequate,
create an analog output connection as shown in Figure 18 on page 71.
When using the external power output, one unused wire must be
connected between the X4-8 connector on the PWD CPU board and the
ground of the data collector at the user's end. One of the following wires
can be used for this if they are not in use anywhere else:
- VIO
- GRY/PNK
- RED/BLU
- PNK
- GRY
For instructions on how to remove the protection board, see Figure 22 on
page 91.
To Next Page
Loading...
