11 Diagnostics
Press 3 in Main menu to access the diagnos-
tics functions.
11.1
Logs
Press 1 Logs to open the menu.
Event log contains the 15 most recent events.
You can view events by pressing Enter or up/
down keys.
• Event log: The event index and the number of events stored in the event log.
• The starting and ending times of events are shown in the next two lines. If the
event is still on or if the ending time was not detected, the ending timestamp is
shown as '--.--.---- --:--:--'. The message Shutdown in the place of the event state
end time indicates that the event state was on when power was shut down. If the
event state is still on when the power is switched on next time, the event is reported
as a new event.
• Error: A text describing the event.
Config trend: The display shows the trend in-
terval (1 min, 2 min, 5 min, 10 min, 20 min)
used as a time stamp in the trend table.
Clear trend: In this display you can clear the
trend memory by pressing Enter. Pressing Esc
cancels the function.
Diagnostics | 41 (48)
K20798 V1.1 EN - 1 - 12/2019
To Next Page
Loading...
