Vanderbilt SPCK520 User Manual

8
User programming via the keypad
User Menus
34
Vanderbilt
Compact Keypad User Manual
I-200004-1
01.10.2015
2. Press ENTER to accept the default user name or enter a customized user
name and press ENTER.
3. Scroll to the preferred user profile type and press ENTER to select.
 The system generates a default PIN for each new user.
4. Press ENTER to accept the default user PIN or enter a new user PIN and
press ENTER.
Where USER DURESS feature is enabled, consecutive user PINs (i.e. 2906,
2907) are not permitted, as entering this PIN from the keypad would activate a
user duress event.
The keypad confirms that the new user has been created.
8.1.9.2 EDIT
To edit users on the system:
1. Scroll to USERS > EDIT.
2. Press SELECT.
3. Edit the desired user setting shown in the table below.
CHANGE NAME
Edit the current user name
USER PROFILE
Select the appropriate profile for this user.
USER DURESS
Enable or disable duress for this user.
DATE LIMIT
Enable this if the user can only access the system for a specified period of time.
Enter a FROM and TO date and press ENTER.
PACE
Enable or disable PACE capability
RF FOB
Enable or disable RF Fob access (wireless keypad, remote control)
MAN-DOWN
(MDT)
Enables the man-down test.
ACCESS
CONTROL
If no card assigned to the user:
 ADD CARD
 LEARN CARD
If a card assigned to the user:
 EDIT CARD
– CARD NUMBER
– CARD ATTRIBUTES (see Access Control)
 RESET CARD
 DELETE CARD
LANGUAGE
Select a language for this user that will be displayed on the system.
8.1.9.3 ACCESS CONTROL
One access card can be assigned to each of the users on the control panel.
To configure the access control for a user:
1. Scroll to USERS > EDIT.
2. Press SELECT.
3. Select the user which should be configured and press SELECT.

Vanderbilt SPCK520 Specifications

General

Brand	Vanderbilt
Model	SPCK520
Category	Keypad
Language	English