Compact Keypad User Manual
5 Login
5.1 Login with PIN
The display in idle state shows an analogue clock as default, but may differ
depending on system configuration.
The keypad is in idle state.
1. Wake up the keypad.
2. Enter the valid user code with the digit keys 0 to 9.
The state of the area/area groups will be displayed.
How to correct input error
Delete incorrect input using the X key and then enter the PIN again.
If the PIN is entered incorrectly a number of times input is blocked for one minute.
Wait for this amount of time then enter the PIN correctly.
5.2 Login with card
The card / fob must be assigned to a user and stored in the control panel.
Present the card / fob to the appropriate area of the keypad.
If the keypad has been fitted with a Mifare receiver, users should present their card
to the LCD display area.
If the keypad has been fitted with a proximity device receiver, users should present
the fob to within 1 cm of the card reader receiving area.
The card reader receiving area is next to the alphanumeric keypad and is indicated
by the following icon:
To Next Page
Loading...
Need help?
General
