User programming via the keypad
Compact Keypad User Manual
4. Enter an SMS PIN for this user and press ENTER.
Keypad indicates that SMS details are updated.
8.1.11.2 EDIT
A modem is installed and identified by the system.
The function SMS Authentication is activated in OPTIONS.
1. Scroll to SMS -> EDIT and press SELECT.
2. Select an engineer or user SMS ID to edit.
Enter the number to which the SMS will be sent (requires three-digit country
code prefix).
Note: Engineer SMS number can deleted by resetting it 0. User SMS
numbers cannot be deleted.
Select a new user for this SMS ID if required.
Select the panel events which the user or engineer will receive via SMS.
Select the operations that the user or engineer can perform remotely on the
panel through SMS. See SMS Commands [➙ 39]
HOLDUP alarm events are not transmitted via SMS.
If the phone line is connected to the PSTN network via a PBX, the appropriate
line access digit should be inserted before the called party number. Ensure that
Calling Line Identity (CLI) is enabled on the line selected to make the call to the
SMS network. Consult the PBX administrator for details.
8.1.11.3 DELETE
1. Scroll to SMS -> DELETE.
2. Scroll to the required SMS ID.
3. Press SELECT.
The keypad indicates that the SMS information is updated.
8.1.11.4 SMS Commands
When the SMS setup and configuration is complete, SMS features may be
activated. Commands, depending on SMS configuration, are sent using a PIN or
caller ID. The type of PIN depends on what is set for SMS Authentication.
The table below provides all available SMS commands. Subsequent action and
response are also provided.
To Next Page
Loading...
Need help?
General
