User programming via the keypad
Compact Keypad User Manual
4. Press BACK to return to the previous screen to amend the PIN.
If the display times out during the process, the old PIN remains valid.
Where USER DURESS feature is enabled, consecutive user codes (i.e. 2906,
2907) are not permitted, as entering this PIN from the keypad would activate a
user duress event.
8.1.13 DOOR CONTROL
This option allows you to control all the doors of the system.
1. Scroll to DOOR CONTROL and press SELECT.
2. Select the door which should be controlled and press SELECT.
3. Select one of the door states listed below as new door state and press
SELECT.
The door is in normal operation mode. A card with the corresponding
access rights is needed to open the door.
The door is opened only for a timed interval to allow access.
The door is locked. The door remains closed even if a card with the
corresponding access rights is presented.
These menu options are not available if the ALLOW ENGINEER or ALLOW
MANUFACTURER options are disabled in the OPTIONs menu. These options
can be enabled or disabled only when the system is in ‘Unrestricted’ mode.
When engineer or manufacturer access has been allowed, the keypad displays the
text ENGINEER ENABLE or MANUFACT ENABLE. When access has been
granted, the user cannot access the system until the engineer has logged off.
To allow engineer access:
1. Scroll to GRANT ACCESS and press SELECT.
2. Select to ALLOW ENGINEER and select ENABLED.
3. Select to ALLOW MANUFACT. and select ENABLED.
4. Select to GRANT SERVICE and enter the installer’s service ID.
5. To disallow engineer/manufacturer access, follow the same path and toggle to
DISABLED and press SELECT.
To Next Page
Loading...
Need help?
General
