Setting and unsetting the system
Compact Keypad User Manual
7 Multi area view
7.1 Setting and unsetting the system
Enter a valid User code
The names of the areas or area groups are displayed.
The current state of the area or area group is indicated on the right in the
display and by the LEDs above the display.
Following states are possible:
Fullset (all areas of the area group are Fullset)
Unset (all areas of the area group are Unset)
Mixed Set (the areas of the area group have different setting states.).
Partset A (all areas of the area group are Partset A)
Partset B (all areas of the area group are Partset B)
To change the state of an area group:
1. Scroll using the ▲ ▼ keys until the required area group is visible.
2. Press the relevant softkey to change the state of the whole area group.
To change the state of a single area (mixed set possible):
1. Scroll using the ▲ ▼ keys until the required area group is visible.
2. Press OK.
All areas of this area groups are listed.
3. Scroll using the ▲ ▼ keys until the required area is visible.
4. Press the relevant softkey to change the state.
To change the state of all areas:
1. Scroll using the▼ key to ALL MY AREAS. (in area group view)
2. Press the relevant softkey to change the state.
To Next Page
Loading...
Need help?
General
