Vatech PaX-i Plus

1. Introduction
PaX-i Plus / Insight Installation Manual 5
Cautions
 It is critical that installers read and understand the installation
instructions fully before installation.
 The installer must confirm that the system is installed
according to the instructions provided by this manual and
perform the appropriate procedures therein.
 If the equipment has been stored at temperatures of below
10℃ (50℉) for more than a couple of hours, allow the
equipment to reach room temperature before applying mains
voltage.
 Installation and related work must only be performed by
people authorized by VATECH.
 Do not connect any items or equipment to this system which
are not part of the system: IEC60601-1-1 (3
rd
edition: 2005).
 Any equipment not approved by VATECH must comply with
the applicable standards: IEC 60950-1 (2
nd
edition: 2005) for
IT equipment (Ex: PC) and IEC 60601-1 (3
rd
edition: 2005) for
medical electrical equipment.
 All operators of this equipment are responsible for ensuring
that the requirements outlined in IEC 60601-1-1 (3
rd
edition:
2005): Safety Requirements for Medical Electrical Equipment
are fully met to ensure the safety of patients, operators and
the environment.
 Never touch sensitive areas such as sensors during
installation. These areas are indicated at the applicable stages
during the installation procedures.
 Use of wireless phones may interfere with the operation of this
equipment.
 Use an ESD (electrostatic sensitive device) wrist band during
installation and connect it to a ground wire.
 Touch a ground point to discharge static electricity before
handling PCB boards.