Vatech PaX-i3D Smart - Cleaning and Maintenance

Pax-i3D Smart(PHT-30LFO) Installation Manual
120
8 Installing Software
3.
Enter the command
PVER
] to verify the current mode. Note that the equipment is now in packing mode.
4.
Enter the command
PKEN_0000
] to exit the packing mode. Now note that the equipment is out of
the packing mode.
Note: to re-enter the packing mode, use the command:
PKEN_0001
].
5.
Click
Exit
button and terminate the control panel.
6.
Exit the imaging program (main GUI)
:
important!
7. Reset the equipment to take the changes into effect