4 Equipment Inspection and Handling
WARNING! Risk of improper moving, lifting, or handling of the unit. Can cause equipment damage, injury or
death. Read all of the following instructions and verify that all lifting and moving equipment is rated for the
weight of the unit before attempting to move, lift, remove packaging from or prepare the unit for installation.
See Table 3.2 on page11.
CAUTION: Risk of contact with sharp edges, splinters, and exposed fasteners. Can cause injury. Only properly
trained and qualified personnel wearing appropriate, OSHA-approved PPE should attempt to move, lift,
remove packaging from or prepare the unit for installation.
NOTICE
Risk of improper lifting. Can cause equipment damage. Make sure that the spreader bars are wider than the unit.
If the spreader bars are too short, the slings may crush the unit.
NOTICE
Risk of damage from forklift. Can cause unit damage. Keep tines of the forklift level and at a height suitable to fit
below the skid and/or unit to prevent exterior and/or underside damage.
NOTICE
Risk of improper storage. Keep the unit upright, indoors and protected from dampness, freezing temperatures
and contact damage.
Upon arrival of the unit and before unpacking:
• Verify that the labeled equipment matches the bill of lading.
• Carefully inspect all items for visible or concealed damage.
• Report damage immediately to the carrier and file a damage claim with a copy sent to Vertiv or to your sales
representative.
4.1 Packaging Material
All material used to package this unit is recyclable. Please save for future use or dispose of the material appropriately.
4.2 Lift Points for Moving the Skid
Refer to the appropriate submittal drawings to locate the lift points for your heat rejection skid located in the Submittal
Drawings.
• Use the indicated lifting points to lift the unit.
• Use spreader bars and/or shimmed blocks to prevent external damage.
• Lift the unit level. Tilting or twisting can damage internal components.
• Use the proper rigging equipment and make sure that attachment and lifting at the designated points is vertical.
4 Equipment Inspection and
Handling
Proprietary and Confidential ©2024 Vertiv Group Corp. 13
Vertiv™ Liebert® MCV Installer/User Guide
To Next Page
Loading...
