Chapter 9 Transferring the 6000A V2 Platform Interface
Establishing connection
66 User Manual 76100000200 Rev. 001
Ethernet IPv6 > Mode
The Ethernet IPV6 parameters must be configured to get Ethernet
access in accordance with the IPV6 standards.
Config 1 to 4 static mode enabling input of the configuration of
4 sites. If this parameter is selected, the following
parameters must be entered:
– Site Name the user can enter the name of the site in the Edit
menu.
– Link: automatically displays the address of the link
(cannot be modified)
– IP IP address of the 6000A V2 Platform
– GW IP address of the machine enabling access
outside the sub-network.
– DNS IP address of the machine providing the IP
address on the basis of the name
Auto in this mode, the 6000A V2 Platform requests an
IP address from the server which will be
allocated automatically.
If Auto is selected, the parameters Link, IP, GW and DNS are auto-
matically defined and cannot be modified.
Off The Ethernet IPV6 connection is not activated.
Proxy > Use proxy
1 Select No if no proxy is used.
If Manual has been selected, enter the Proxy Address.
If Auto has been selected, enter the Pac Address.
2 Note the IP Address displayed in the System Settings page.
NOTE
Once the 6000A V2 Platform is connected to the network, the icon
displays for few seconds and indicates the connection is working.
Fig. 35 Example of proxy configuration
To Next Page
Loading...
