Vigilant MX1-Au Operator Manual Document: LT0439
Page 23 October 2018 Issue 1.73
100V a.c. audio line wiring is defined as LV
Telecommunications circuits and is subject to the
Australian Standard AS/ACIF S009:2006.
Ensure that this wiring is appropriately separated and
insulated from LV power wiring, ELV and other
customer cabling such as detection and control
circuits.
This is a Class A product. In a domestic environment this
product may cause radio interference, in which case the
user may be required to take adequate measures.
Some of the operation of the MX1 as described in this
manual is dependent on the site-specific configuration
performed by the installer. If the configuration is non-
standard, then operation may differ from this manual and
compliance to local Standards may be invalidated.
The MX1 has facilities to protect against unauthorised use
of operator controls by means of Access Levels. The
configuration of your system may result in Access Levels
that differ in some respects from this manual.
Except where otherwise stated, this manual refers to MX1
Controller firmware version 1.7.
Information provided in this manual may remain valid for
subsequent versions of Controller firmware. However if a
different version of firmware is installed, a more appropriate
version of this manual may be required.
To Next Page
Loading...