Violin Memory 6000 Series - CHAPTER 2. System Setup and Configuration

535-0045-00 Rev 02 Violin 6000 Series Memory Array Installation Guide 31
CHAPTER 2 System Setup and Configuration
When a new Violin 6000 Memory Array is powered on for the first time, all
configuration settings remain at their default values. You must change the default
settings to communicate with the Memory Array over your network(s).
This chapter explains how to update and set up the system settings on a new Violin
6000 system using the configuration wizard in the following sections:
• Completing the Configuration Wizard on page 32
• System Verification and Management on page 37
• Troubleshooting on page 47
Note: If you connected the Memory Array directly to a host machine using PCIe
cables, you must install a driver to enable the host machine to access block storage
on the Array. See “Violin Drivers” in the Violin 6000 Series Memory Array User’s
Guide after completing the configuration steps in this chapter.