Chapter 2: System Setup and Configuration
44
Violin 6000 Series Memory Array Installation Guide
535-0045-00 Rev 02
Verifying Memory Gateway Addresses and Licenses
This section covers the tasks for verifying the public IP addresses on the internal Memory Gateways
and the vSHARE feature license. Complete both tasks.
To verify public IP addresses on the internal Memory Gateways, do the following:
1. From a system on the network other than the Memory Array being configured, verify that all
three configured public addresses (one each per Memory Gateway and their shared
management VIP) respond to pings.
2. Using SSH, verify that the CLI is accessible on the public gateway VIP by connecting to the
management VIP address as user admin.
3. Verify that the Web interface is accessible on the public gateway VIP by opening a supported
Web browser and entering the management VIP address. When prompted, log in as user
admin.
To verify the vSHARE feature license, do the following:
1. Log in to the CLI of the master Memory Gateway. This can be either the externally accessible
management VIP or the internal IP address of the gateway that is the master.
2. In enable mode, run the show licenses command to display the currently installed licenses.
You should see output similar to the following example:
3. If there is not a license for a feature and/or the feature is not active, install the correct license
for the given cluster ID using the following command:
license install <license key> Where <license key> is the key printed on the
side of the Memory Array.
4. Continue to Initializing the Violin Memory Array on page 45.
violin-vmga [violin-vmg: master] # show licenses
License 1: LK2-RESTRICTED_CMDS-7X77-4GKJ-E9T8-8A48-9JQ1-X4J7
Feature: RESTRICTED_CMDS
Valid: yes
Tied to cluster ID: 99999 (ok)
Active: yes
License 2: LK2-VMOS6-7X87-4VKJ-
Feature: VMOS6
Valid: no
Active: no
License 3: LK2-VMOS6-7X87-4VKJ-E9R8-8A1L-48H4-9EGQ
Feature: VMOS6
Valid: yes
Tied to cluster ID: 99999 (ok)
Active: yes
To Next Page
Loading...
