Violin Memory 6000 Series - Completing the Configuration Wizard; Default System Settings

Chapter 2: System Setup and Configuration
32
Violin 6000 Series Memory Array Installation Guide 535-0045-00 Rev 02
Completing the Configuration Wizard
When a new Violin 6000 Memory Array is powered on for the first time, all configuration settings
remain at their default values. Follow the steps in this section to configure the Memory Array for the
first time.
Default System Settings
The Memory Array’s default settings are listed in Table 2.1. Change these settings using the CLI
over a SSH session or using a serial port connected to the Memory Array.
Setting Name Default Value
Cluster Name vmem-array
Host Name vmem-array-acma
vmem-array-acmb
IP Addresses 192.168.1.10 (ACMa, static)
192.168.1.11 (ACMb)
192.168.1.12 (ACM Management IP address)
also known as a VIP (Virtual IP address)
IP Netmask 255.255.255.0
IP Default Route 192.168.1.1
Clock Source NTP
Shell Connectivity Serial, SSH (port 22)
Serial Port Settings 9600 Baud, No Parity, 8 bits, 1 stop
User Name "admin"
Password blank
Flash VIMM Format 65% for SLC
84% for MLC
Table 2.1 Memory Array System Default Settings