Multipath Setup
535-0045-00 Rev 02 Violin 6000 Series Memory Array Installation Guide 57
Editing the multipath.conf File
This section presents the recommended configuration file for multipathd for use with a Violin
Memory Gateway. The following is an example multipath.conf file for CentOS/RHEL 6.x for
both ALUA and non-ALUA LUNs. Contact Violin Memory Customer Support for assistance with
other supported distributions.
1. Edit the multipath.conf file, uncommenting entries, similar to the following example. The
devnode_blacklist includes devices for which you do not want multipathing enabled.
To Next Page
Loading...
