Vishay 7000 - Limits Group; Set Limit Type Command; Set Number of Limit Event Conditions Command

Vishay Micro-Measurements System 7000 Programmer’s Reference Manual
Page 119 of 142
7.4.4 Limits Group
Limits group commands are only valid while the system is in the idle state.
7.4.4.1 Set Limit Type Command
Length Command
Group
Command
Code
Card Mask Channel
Mask
Parameters
0x0007 0x04 0x0001 Used Ignored
0x00
Byte 8:
Limit Type:
0x00 None, default
0x01 Incremental
0x02 Range
0x03 Normal
This command sets the limits-based recording mode for the selected card(s).
7.4.4.2 Set Number of Limit Event Conditions Command
Length Command
Group
Command
Code
Card Mask Channel
Mask
Parameters
0x0008 0x04 0x0002 Used Used Bytes 8-9:
The number of limit
conditions.
This command sets the number of limit event conditions for the selected channel(s).
Range: 0 to 50
Default: 0