Vishay 7000 - Setlimitsbasedrecordingtype Method; Configurelimitsbasedrecording

Vishay Micro-Measurements System 7000 Programmer’s Reference Manual
Page 74 of 142
6.5.4.6 SetLimitsBasedRecordingType Method
Syntax:
HRESULT _stdcall SetLimitsBasedRecordingType(in long CardNo, in long Action, out retval
long * result );
Description:
The recording type determines the recording action of a card when a limit condition is detected
when the limits type is set to Normal mode.
Arguments:
CardNo The card number (1-16).
Action 0 - Off: No recording when a limit is detected (default)
1 - Record while limit active: Records scans while the limit condition remains
active. Recording stops when the limit condition goes inactive.
2 - Singleshot: Records a single scan when a limit condition goes active
3 - Continuous: Recording starts when a limit condition is detected and continues
until scanning stops
Returns:
0 if Successful, otherwise an Error Code
Notes:
See SetLimitsType method
6.5.4.7 ConfigureLimitsBasedRecording
Syntax:
HRESULT _stdcall ConfigureLimitsBasedRecording (in long CardNo, in long GroupMask, in
long Mode, in long SkipCount, in long BurstCount, in long BurstSkipCount, out retval long *
result );
Description:
This method is used to configure limits-based recording for one or more recording groups..