Vishay Micro-Measurements System 7000 Programmer’s Reference Manual
Page 70 of 142
6.5.3.10 StartSynchronizedScanning Method
Syntax:
HRESULT _stdcall StartSynchronizedScanning(out retval long * result );
Description:
This method starts synchronized scanning on a synchronized network. On a synchronized
network, the StartScanning command prepares for scanning, but waits until this command is
executed before actually scanning
Arguments:
None
Returns:
0 if Successful, otherwise an Error Code
Notes:
This command must only be sent to the scanner designated as the Master. All cards in the
synchronized network must be issued the StartScanning method before this command is executed.
To Next Page
Loading...