Vishay Micro-Measurements System 7000 Programmer’s Reference Manual
Page 12 of 142
Limits-Based Recording Setting Idle
Set Limits-Based Recording Mode Idle
Set Limits-Based Recording Skip Count Idle
Set Limits-Based Recording Burst Count Idle
Set Limits-Based Recording Burst Skip Count Idle
Scan
Set Scan Rate Idle
Create Scan List Idle
Set AutoStop Idle
Get Last Data File Information Idle
Set Scanner ID in Scan Header File Idle
Set Project Name in Scan Header File Idle
Set a Descriptor in Scan Header File Idle
Set a GUID in Scan Header File Idle
Set a IP Address in Scan Header File Idle
Set the Size of the Scan Buffer Idle
Limits
(Recording)
Set Limit Type Idle
Set Number of Limit Event Conditions Idle
Set Limit Event Condition Idle
Set Lower Limit Value Idle
Set Upper Limit Value Idle
Set Pre-Limit Buffer Size Idle
Set Post-Limit Buffer Size Idle
Ignore/Accept Sync (Global) Limits Idle
Set Pre-Limit Buffer Size for Sync (Global) Limits Idle
Set Post-Limit Buffer Size for Sync (Global) Limits Idle
System
Set Date/Time Idle
Get Free Space on Compact Flash on Control Module Idle
Configure Online Data Idle, Scanning
Define Scanner’s Network Configuration Idle
Verify Sync Cable Status Idle
Card Detect Idle
Clear Errors Idle
Get Control Module Information Command Idle
Display Flashing LED Sequence Idle
System Status Query ALL
Convert System Error Code to Text Idle, Armed, Scanning
Action
Arm Idle
Disarm Armed
Start Scaning Armed
Stop Scanning Scanning
Start Manual Recording Scanning
Stop Manual Recording Scanning
Start Online Data Transfer Scanning
Stop Online Data Transfer Scanning
Synchronize Network Scanners Armed
Start Scanning on Networked Scanners Scanning
File
Retrieve File from AIM Card Idle
List Files on AIM Card Idle
Delete File on AIM Card Idle
Cancel File Transfer Uploading
List Files on Control Module Idle
Retrieve File from Control Module Idle
Delete File from Control Module Idle
Table 4 – Command List
To Next Page
Loading...