Alarm Out
The Alarm out relay can be set to activate on the following occurrences: Video Loss;
Alarm input; Motion detection; Power Loss; Smart (Hard disk monitoring).
The duration of the activation can be set.
Relay Follower
This allows the full screen images of several DVRs to be viewed on a single monitor.
A relay can be set to close each time a camera is selected.
This relay closure can be used as the Alarm input to a switcher, such as the VS042A.
If the Monitor outputs from several EVO‟s are taken to the inputs of this switcher, then
each time a camera is selected, the switcher will change it‟s output to the relevant
DVR monitor picture.
This allows the full screen images of several DVRs to be viewed on a single monitor.
To Next Page
Loading...
