The Symbols and text displayed on
screen can be controlled:
1. The status bar can be set to
be off/ Always on or be on
for 5 or 10 seconds after a
key press.
2. The Event symbols such as
Motion, Audio, Pan / Tilt can
be displayed or turned off.
3. The camera name can be
displayed or turned off.
4. The PTZ display can be
made to time out
5. The Password entry box
can be made to time out
6. The darkness of the status
bar can be varied.
If channels are set to Disconnected,
then:
1. No OSD info will be displayed in
associated screen spilt segments.
2. Cameras cannot be allocated
recording rates within the record set
up
3. Camera inputs will not be included
in sequences.
To Next Page
Loading...
