The internal buzzer can be set to sound
on the following occurrences:
Video Loss
Alarm activation
Motion Detection
Power loss
Smart
Duration – This sets the length of time
for which the buzzers sounds.
The Alarm output relay can be set to
activate on the following occurrences:
Video Loss
Alarm activation
Motion Detection
Power loss
Smart
Duration – Set the length that the relay is
active.
Relay follower: If set to YES the relay
closes when a camera is selected. This
output can trigger an alarmed switcher to
switch the video output to the input
relating to that DVR, This allows a single
monitor to be used to view multiple
DVRs. ( One at a time)
To Next Page
Loading...
