3. operation
SETUP
Change the settings of the MP-
D201
OUTPUT
Change between XLR out or RCA
out.
DAC VOL
Turn the volume control of the
MP-D201 on and off.
DATA
Shows information about this
MP-D201.
HW vx.xx
Hardware version
SW vx.xx
Software version
xx-20xx
Last updated
RESET
Restore the settings of the
MP-D201 to its default settings.
V.INIT
Change the initial dB step of the
volume in the MP-D201 to any
step between -99 and12.dB
VOL.STEP
The MP-D201 has a standard
volume step of -40 dB. You can
set the volume step to a step,
between -99 dB to 0 dB. This step
will be the new volume step. Even
when after the power cord has
been disconnected the MP-D201
still starts up in the new volume
step.
REMEMBER
Set the MP-D201 to remember
the current volume step. The MP-
D201 will start up in this volume
step when it leaves standby.
This volume step however is not
remembered when the power
cord is removed. Then the MP-
D201 will initiate in the volume
step as it is defined in the V.INIT
sub-menu.
BRIGHT
Change the brightness of the
display any step between 0 and 3.
INPUTS
Change settings for each input.
INPUT X
Change the settings of input X.
TEXT
Choose a name for input X.
OFFSET
Select an offset- gain, between
-12 and 12 dB, for input X.
SET FIX
Set the volume of input X to a
fixed dB step. (Input X is now
locked to a dB step and can not
be adjusted with the volume
control)
FIXED
Lock and unlock the volume by
switching between FIX ON/FIX
OFF.
ADJUST
Adjust the fixed dB step to any
step between -99 and +12 dB
MP-D201 Menu: discription of the elements.
To Next Page
Loading...