4. operation & service
Mains fuses
The mains fuses are accessible
from the outside of the
amplifier. You will find the
mains fuses just below the
power inlet. If the fuses blow,
then you can easily replace
them. The fuses only blow
on the occurrence of power
surges or if there is a fault
in the unit. Normally power
surges cause no other damage
other than blowing the
fuses. When the fuses blow
repeatedly on replacement,
then the unit most likely has
a malfunction. In case of
malfunction the unit must be
returned to Vitus Audio for
repair.
Fuse type:
230V : 20 x 5mm – 1 A – T -
LBC fuse (Time lag fuse)
100-120V : 20 x 5mm – 2 A – T -
LBC fuse (Time lag fuse)
Replacing the fuses with fuses of a type
and rating different from the original
fuses, might result in damage to the unit
and injury to you (the user). Damage to
the unit as a result of wrongly replacing
the mains fuse, will invalidate the
guarantee.
For an explanation of how to replace the
fuse see “Replacing a blown fuse”chapter 4.
4. operation &
service
To Next Page
Loading...