8. RC-010 operation
The menu structure
You can modify the settings
of the RC-010. You do this by
entering the menu. On the nex
page you can find a graphical
reproduction of the menu.
The sub-menus are indicated
with a colour. FABRIC, ADD
PRODUCT, DISPLAY, EDIT
PRODUCT and PROGRAM
KEY. On the next page you
can find a discription of the
elements in the menu. In the
Appendix you can find various
examples of how to change
the settings of the RC-010.
FABRIC
Restore the settings of the RC-
010 to factory settings.
ADD PRODUCT
The RC-010 comes has a list
installed of 12 predefined
products. There is room for
14 products on this list. This
means that it is possible to add
2 more products.
DISPLAY
The remote contains a motion
sensor. The RC-010 enters
a power down mode when
the motion sensor has not
registered movement for some
time. You can awake the RC-
010 movement, or by pressing
a key. In this sub-menu, you
can change the power down
time delay, the time it takes
before the RC-010 enters
power down mode.
It is possible to set the delay
to: OFF, 1,2,3,4,5 and 10
seconds.
When you select OFF, the
remote shuts down as soon as
you stop pressing a button.
With OFF selected the motion
sensor is deactivated and
movement will not activate the
RC-010.
EDIT PRODUCT
The products in the list of
predefined products are fully
programmed. You can disable
or delete the products in the
list or you can change the
settings for buttons 1 and 3
(the hotkeys). When you add
a product to the list then you
have to program the buttons.
PROGRAM KEY
This sub-menu only becomes
available when you add a
product to the predefined
product list. In this sub-menu
you can enter the buttons
RC5 code and give the button
a name. You can give each
button 2 functions. One
function for pressing (release),
and one function for press-
and-hold (press).
8. RC-010
operation
To Next Page
Loading...