EasyManua.ls Logo

VKI Technologies Suprema - Counters; Programming the Equipment; Viewing and Resetting Counters

Default Icon
58 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SUPREMA - OPERATION & SERVICE MANUAL
Page 12 of 58 02-2012 Suprema - Operation & Service
PROGRAMMING THE EQUIPMENT
The first section of the "SET-UP" mode displays all the counters. These counters can be reset
while in this mode. The following table lists all the counters in the order in which they appear
at the beginning of the "
SET-UP" mode;
CASHBOX TOTAL
VEND TOTAL
(RESETTABLE) VEND TOTAL RESET
TOTAL / SELECTION
COIN DISPENSE --- appears only in "COIN" mode
FREE VEND TOTAL
Viewing and Resetting Counters
When the Cash Box Total reaches $220, the machine will display a CALL KEY OPERATOR
message on the LCD. This indicates that the cash box must be emptied and the counter must be
reset.
1. Enter the "
SET-UP" mode.
a) Press the
"SET-UP" mode button on the interior door panel. The display will now
read,
b) To reset the "CASHBOX TOTAL", press the "START" button. To scroll to the next
counter, press the "
UP" button on the hidden menu scroll buttons.
c) The next counter is the "
VEND TOTAL" counter. This counter can only be viewed
and it is not possible to reset it at this point. To scroll to the next counter, press the
"
UP" button on the hidden menu scroll buttons.
d) The next counter to be displayed is the
"VEND TOTAL RESET" counter (resettable).
Press the
START button to reset, if needed.
e) The next counter to be displayed is the "
TOTAL/SELECTION" counter. Press the
START button to reset the counters.
A confirmation message will appear after
START is pressed. To reset the
counters, press
START again. To cancel the reset, press the COFFEE button.
f) The next counter to be displayed is the "
FREE VEND TOTAL" counter. Press the
START button to reset, if needed.
CASH BOX
TOTAL= $XXXX.XX
Note:
While in the “SET-
UPmode, pressing
the “SET-UP” button
once again will exit
this mode and save
all changes made to
the programming.
Note:
The “VEND TOTAL
counter can only be
reset by performing
a “TOTAL COUNTER
RESET”.
Tip:
The “VEND TOTAL
counter can also be
viewed by pressing
the “COFFEE”, “50/50
and “DECAF” buttons
simultaneously. It will
appear immediately
after the product
status is displayed.

Table of Contents