SUPREMA - OPERATION & SERVICE MANUAL
Page 52 of 58 02-2012 Suprema - Operation & Service
Removing the Fuse Box Assembly
1. Switch off the machine power and disconnect the service cord from the wall outlet.
2. Remove the brewer.
3. Remove the brewer bracket assembly.
4. Disconnect the wires identified in the table below.
#11 on water tank harness
Ground stud on rear board cover
#1-2 on water tank harness
5. Disconnect the ground wire attached to the left wall of the machine.
6. Remove the two screws securing the fuse box.
7. Lift and pull on the fuse box to remove it.
Installing the Fuse Box Assembly
1. From inside the cabinet, put the service cord through the fuse box location cutout in
the back of the cabinet.
2. Place the fuse box into position.
3. Align the holes on the fuse box with the holes on the cabinet wall.
4. Secure with two screws.
5. Connect the wires identified in the table below.
#11 on water tank harness
Ground stud on rear board cover
#1-2 on water tank harness
*For more information about wiring, consult the wiring section of this manual.
6. Connect the ground wire to the cabinet wall.
7. Replace the brewer bracket assembly.
8. Replace the brewer.
9. Plug in the service cord.
10. Switch the coffee maker "ON".
Tip:
When the fuse box is
removed, make sure
you inspect the wiring
and the tabs inside
the box before re-
installing it.
To Next Page
Loading...