SUPREMA - OPERATION & SERVICE MANUAL
Page 24 of 58 02-2012 Suprema - Operation & Service
Setting Number of Chocolate Pump Cycles
This feature will allow you to program the number of chocolate pump cycles for any cup size.
The unit is preset to the following from the factory:
1. To set the number of chocolate pump cycles for each cup, press the "UP" button on
the hidden menu scroll buttons until the following message appears,
a) Press the "START" button to enter the set mode.
b) Select the cup size and product to be programmed on the front selection panel.
c) Using the hidden setting adjustment buttons, increase or decrease the number of
pump cycles. Maximum is 8 for hot chocolate and 3 for café mocha.
d) To set, press either one of the two hidden menu scroll buttons.
Setting the Double Cup
Any one of the three cup sizes can be programmed to dispense a double-cup (two consecutive
cups) of coffee or cafe mocha using this feature. For example, if you would like to brew a 20-
oz. cup of coffee, it is possible to set a 10-oz. large cup to brew a double-cup.
1. To program a cup to be a double-cup, press the "UP" button on the hidden menu
scroll buttons until the following message appears,
a) Press the "
START" button to enter the set mode.
b) On the front selection panel, press the cup size that needs to be programmed to
become a double-cup. The LED that corresponds to that cup size will illuminate as
an indication that it has been programmed as a double-cup.
c) To program back to single cup, repeat the above procedure. Pressing the cup size
will switch the LED off, which indicates the double-cup feature is disabled for that
cup size.
Please note that if the carafe feature is enabled, it overrides the double-cup feature if the
double-cup is set for the large cup (this does not apply is double-cup is set on the small or
medium cup).
CHOCO PUMP
PRESS <START>
DOUBLE-CUP
PRESS <START>
Note:
If the number of
“CAFE MOCHA” pump
cycles has been
changed for a
particular cup size, it
is necessary to enter
the “SET-UP” mode to
adjust the product
and water levels for
that cup size.
Note1:
Once a cup size is
programmed to brew
a double-cup, it will
no longer brew a
single cup.
Note2:
The double-cup
feature is not
available for hot
chocolate. For hot
chocolate, increase
the number of
chocolate pump
cycles.
To Next Page
Loading...