EasyManua.ls Logo

VKI Technologies Suprema - Setting Water; Setting Prices

Default Icon
58 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SUPREMA - OPERATION & SERVICE MANUAL
Suprema - Operation & Service 02-2012 Page 17 of 58
Setting Water
1. To adjust water settings, press the "UP" button on the hidden menu scroll buttons
and scroll until the following message appears,
a) Press the "START" button to enter the set mode.
b) At this point, you can now select the water settings for any cup size and product by
pressing the appropriate buttons on the selection panel. The time setting displayed
will correspond to the cup size and product LED's that are illuminated.
c) Using the hidden setting adjustment buttons, increase or decrease the timing for the
water.
d) To exit the "
SET WATER" mode and proceed to the next setting, press the "UP" or
"
DOWN" scroll buttons.
Setting Prices
To operate this equipment in “COIN” mode, an optional Coinco 9300 series coin changer must
be installed. This changer can be purchased from your local Coinco retailer. Installation
instructions for the coin changer and pricing decals can be found on page 57 of this manual.
1. To adjust price settings, press the "
UP" button on the hidden menu scroll buttons
and scroll until the following message appears,
a) Press the "
START" button to enter the set mode.
b) At this point, you can now select the price setting for any cup size and product by
pressing the appropriate buttons on the selection panel. The price setting displayed
will correspond to the LED's that are illuminated.
c) Using the hidden setting adjustment buttons, increase or decrease the price.
d) To exit the "
SET PRICE" mode and proceed to the next setting, press the "UP" or
"
DOWN" scroll buttons.
SET WATER
PRESS <START>
SET PRICE
PRESS <START>
WARNING: Do not press the “START” button to exit this mode as it will do a
test cycle and dispense water. This does not apply to “
CAFE MOCHA”, as there
is no test cycle for this product.
Note1:
The minimum
allowable setting for
water is 0.5 seconds,
and the maximum is
8.0 seconds for
coffee water and
20.0 seconds for
"HOT WATER".
Note2:
When adjusting the
water level for the
CAFE MOCHA”, only
the chocolate valve
timing is adjusted.
The coffee valve
timing remains
unchanged as it is
calculated by the
microprocessor.
Note:
The maximum
allowable price
setting is $12.75.
This is the maximum
setting per cup, as
well as for a
complete carafe.

Table of Contents