SUPREMA - OPERATION & SERVICE MANUAL
Suprema - Operation & Service 02-2012 Page 19 of 58
Setting the Default
1. To program the default settings, press the "UP" button on the hidden menu scroll
buttons and scroll until the following message appears,
a) Press the "START" button to enter the set mode.
b) The LED's that correspond to the current default setting will now be illuminated.
c) To change the default, press the buttons on the selection panel for the new default
settings. The LED's that are illuminated will now become the new default settings.
d) In no default is set, the LED’s on the selection panel will light and scroll until the
user selects one. This applies for the products, strengths, and cup sizes, therefore
three selections will be required by the user.
e) To exit the "
SET DEFAULT" mode and proceed to the next setting, press the "UP" or
"
DOWN" scroll buttons.
Setting the Top Pause
The “TOP PAUSE” occurs when the brewer is at top dead center, and is before the regular pause.
When the piston reaches top dead center in the cylinder, the brewer will pause for the amount
of time set in this menu, to allow the coffee and water to steep (mix together). The higher the
"
TOP PAUSE" is set to, the stronger the cup of coffee that is brewed by the equipment.
1. To set the "
TOP PAUSE" setting, press the "UP" button on the hidden menu scroll
buttons and scroll until the following message appears,
a) Press the "
START" button to enter the set mode.
b) At this point, select the cup size by pressing the appropriate buttons on the
selection panel. The "
TOP PAUSE" setting displayed will correspond to the cup size
that is illuminated.
c) Using the hidden setting adjustment buttons, increase or decrease the timing for the
"
TOP PAUSE".
d) To exit the "
SET TOP PAUSE" mode and proceed to the next setting, press the "UP"
or "
DOWN" scroll buttons.
SET DEFAULT
PRESS <START>
SET TOP PAUSE
PRESS <START>
Note:
The minimum “TOP
PAUSE” setting is
2.0 seconds.
To Next Page
Loading...