VKI Technologies Suprema - Product ON;OFF; Setting Products

SUPREMA - OPERATION & SERVICE MANUAL
Page 16 of 58 02-2012 Suprema - Operation & Service
Reminder: The “INCREASE” (+) and “DECREASE” (-) buttons are located to the right of the “START”
button, and the “MENU SCROLL UP” and “MENU SCROLL DOWN” buttons are located to the
left of the “START” button. See page 4 for illustration.
Product ON/OFF
This feature allows you to run a complete coffee or hot chocolate cycle (including the two
pauses) without any product being dispensed (no coffee or chocolate). This will allow you to
manually test brew different coffee blends for the customer to taste. The customer can then
decide which blend he prefers. To use it as a test brew cycle, simply weigh and manually pour
the coffee grounds into the brew chamber, and press the "
START" button. This procedure can be
repeated if you need to test brew another blend.
1. To switch the product
OFF, press the "UP" button on the hidden menu scroll buttons
and scroll until the following message appears,
a) Press the "START" button to enter set mode.
b) Switch the product "
OFF" or "ON" by using the hidden setting adjustment buttons.
Press the "
UP" button to toggle it "OFF" or "ON".
c) To exit the "
PRODUCT on-off" mode and proceed to the next setting, press the
hidden "
UP" or "DOWN" scroll buttons.
Setting Products
1. To adjust product settings, press the "UP" button on the hidden menu scroll buttons
and scroll until the following message appears,
a) Press the "START" button to enter the set mode.
b) At this point, you can now select the product settings for any cup size, product and
product strength by pressing the appropriate buttons on the selection panel. The
time setting displayed will correspond to the LED's that are illuminated.
c) Using the hidden setting adjustment buttons, increase or decrease the timing for the
product.
d) To exit the "
SET PRODUCT" mode and proceed to the next setting, press the hidden
"
UP" or "DOWN" scroll buttons.
PRODUCT ON/OFF
PRESS <START>
SET PRODUCT
PRESS <START>
Note:
If the product is
switched “OFF”, it
remains off until you
enter the “SET-UP”
mode to switch it
“ON” again. Please
make sure it is
switched “ON”
before you leave the
account.
Note:
The minimum
allowable setting
for all products is
0.5 seconds, and
the maximum is
8.0 seconds.
Tip:
While in the “SET
PRODUCT” or “SET
WATER” menus, you
can test the product
and water quantities
by pressing the
“START” button. The
product or water
tested will correspond
to the LED’s
illuminated on the
front selection panel.
Make certain you
have something ready
to catch the coffee
grounds or water that
will be dispensed.