VKI Technologies Suprema - Drain Valve

SUPREMA - OPERATION & SERVICE MANUAL
Page 48 of 58 02-2012 Suprema - Operation & Service
Removing the Drain Valve
To remove the drain valve on a plastic water tank, it will be necessary to drain and completely
remove the tank from the coffee maker. The drain plug can only be removed from the interior
of the water tank.
1. Remove the water tank.
a) Refer to the "
Removing the Water Tank" instructions in this manual.
2. Remove the drain valve.
a) Remove the upper and lower clips on the drain plug.
b) Push drain plug upwards until it goes through the bottom of the tank (to the inside).
c) Remove the tank lid.
d) Reach inside the tank and remove drain plug.
Installing the Drain Valve
1. Install the drain valve.
a) Remove tank lid.
b) Add new o-rings to the drain valve.
c) From the top of the tank, push the drain valve through the bottom (front tube).
d) Install the clips. The smaller clip goes on the top slot, and the larger goes on the
bottom slot of the drain valve.
WARNING: To avoid severe burns, make absolutely certain that the
heater element is not hot before proceeding!
Note:
The center tube at
the bottom of the
tank is for the
water inlet hose
fitting, and the rear
tube is not used.