SUPREMA - OPERATION & SERVICE MANUAL
Suprema - Operation & Service 02-2012 Page 25 of 58
“Press-Hold” Hot Water Setting
Hot water can be programmed to be dispensed in one of two ways. With this feature set to
"
OFF", if hot water is selected and the “START” button is pressed, the cup will completely fill
with hot water. For example, if a large cup of hot water is selected, the quantity of hot water
programmed for that cup size (in the "
SET WATER" mode) is dispensed. However, if this feature
is switched to "
ON" and hot water is selected, hot water will only be dispensed as long as the
hot water button is kept pressed. Releasing the button will stop the flow of hot water.
1. To set the "
PRESS-HOLD HOT WATER" setting, press the "UP" button on the hidden
menu scroll buttons and scroll until the following message appears,
a) Press the "START" button to enter the set mode.
b) Using the "
DOWN" hidden setting adjustment button ONLY, select "ON" or "OFF".
Setting the Temperature
1. To set the temperature of the water in the tank, scroll the menu that reads,
a) Press the “START” button. The bottom row of the display will now indicate the
currently programmed temperature setting.
b) Using the hidden setting adjustment buttons, increase or decrease the temperature
for the water tank.
c) When programmed, this will be the maximum temperature to which the water will
heat. Once the water has reached this temperature, the heater will switch off.
Setting the “WARMING UP” Warning Message
a) Press the “START” button to get back to the main menu, and scroll to the
“
MESSAGES on/off” menu.
b) Press “
START” to enter this menu, and scroll to the “TEMP IS TOO LOW”
message by pressing the “
START” button.
c) This message can be set to “
ON –ACTIVE”, “ON-PASSIVE” or “OFF”. If the
message is set to “
ON-ACTIVE”, the “WARMING UP” message will appear after
the temperature in the tank drops about 20° F, and the unit will no longer
function until the temperature gets back to its proper operating range. Set to
“
ON-PASSIVE”, the message will appear on the display, but the unit will
continue to function normally.
PRESS-HOLD WATER
PRESS <START>
SET TEMPERATURE
PRESS <START>
Tip:
To toggle between
Fahrenheit and
Celsius, press the
“LARGE CUP” button
while in the "SET
TEMPERATURE" menu.
Note:
If this setting is
switched “ON”, it is
not possible to set a
price for hot water. If
switched “OFF”, a
To Next Page