Service and maintenance
Electrical system 133
Light bulb, replacing
1 Place the machine in service position, see page 95.
2 Open the engine hood.
3 Remove the screw (A) by the outer edge on the headlight
console.
4 Fold out the headlight console.
5 Loosen the rubber cap on the headlight.
6 Disconnect the cable terminal from the light bulb.
7 Open the lock clamp.
8 Change the light bulb.
9 Reinstall the cable terminal and the lock clamp.
10 Reinstall the rubber cap.
NOTE! The rubber cap's drain tube shall point downward.
11 Fold in the headlight console.
12 Reinstall and tighten the screw.
13 Close the engine hood.
NOTE! Do not touch the glass bulb on the new light bulb with
your fingers.
A9006800
A
AScrew
To Next Page
Loading...
